![]() ![]() ![]() The reset function is used when using multiple Color Selectable lighting products operating from the same light In the event multiple fixtures are not displaying the same color at the same time, fixtures must be RESET using your existing light switch.If the fixture is left 0N for over 20 seconds then turned OFF, the fixture will remember the last color temperature selected and will display that color when turned on Toggle your light switch 0N and OFF within 5-3 seconds to cycle through the three different color temperatures.Ĭ. Set the slide switch on back of the fixture to “SWITCH”ī. To change color temperatures using your existing light switch:Ī.When the slide switch is set to SWITCH, the color temperature can be changed from SW-BW-DL with your existing light.When the slide switch is set to DL (Daylight), the color temperature fixes at.When the slide switch is set to BW (Bright White), the color temperature fixes at.When the slide switch is set to SW (Soft White), the color temperature fixes at.Soft White – Bright White – Daylight – Light Switch Marks on the fixture: SW-BW-DL-Switch.You can lock in one color temperature, change among multiple color temperatures, dim from 10%-1009’», memorize the last color temperature, and reset.Once the fixture has been raised and is flush to the ceiling as shown, lock the Fixture by moving it towards the opposite direction it was raised. Raise the Fixture to the direction of the arrow on the swingarm.Feed the junction box and fixture wires through the mounting bracket plate’s center hole into the junction box.Insert swing arm’s keyhole slot into the mounting bracket plate’s hanging screw, as shown.Refer to the “Changing Color Settings” instructions on the next page. NOTE: Please select the preferred color temperature by using the switch behind the fixture. Connect the 3 wires coming from the fixture to the Junction box wires (black – line voltage, white – neutral and green – ground).Hook the support wire from the fixture on the mounting bracket plate, as shown.Once the wings are through the drywall and have expanded, pull the screw down to engage the wing on the backside of the Once engaged, secure into place by tightening the screws. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |